crwdns2933803:03crwdne2933803:0
crwdns2933797:0Bill Gilbertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bill Gilbert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Measure the resistance between the two white wires as shown in this document. |
|---|---|
| + | [* black] Insert a probe next to each wire and touch the metal piece that forms the socket. |
| + | [* black] You can do this from the wire side of the connector or remove it from the control board and test from the other side. |
| + | [* black] Note the resistance and consult the Result and SVC Action portion of the chart shown. |
| + | [* black] If the measurement shows a short circuit (zero resistance) cut one wire at the thermistor and check it again. If there is still a short The |
| + | [* black] If the measurement shows open (infinite resistance), check the resistance at the thermistor itself you can either pierce the insulation or |