crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:09crwdne2933803:0

crwdns2933797:0Andrew Optimus Goldheartcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Optimus Goldheart

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Once all the adhesive strips have been applied, reassemble your iPad and install your front panel assembly.
-[* black] Before closing your front panel, use a pair of tweezers to peel the clear backing up off each adhesive strip.
-[* icon_reminder] Make sure that each adhesive strip is placed in the correct location and orientation before peeling the backing.
-[* black] Some of the adhesive strips are small and may require some patience to peel the backing.
+[* black] Use a dry microfiber cloth to clean the LCD and inside of the front panel glass. You may want to use canned air or an air compressor to blow away and dust.
+[* black] Use a pair of tweezers to peel the clear backing up off each adhesive strip.
+[* icon_note] Close the front panel down onto the iPad, careful to place it within the plastic bezel, and careful not to get any dirt or fingerprints between the glass and LCD.
+[* icon_note] To ensure a good seal, place the iPad face down on a padded envelope or cloth and pile a couple of books above it to weigh the screen down. Leave it like this for a few hours before using.