crwdns2933805:0crwdne2933805:0
crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Insert the flat end of a spudger underneath the three main ribbon cable connectors and pry them up gently. |
|---|---|
| + | [* icon_note] The connector at the "OCTA" label on the ribbon cable is not connected directly to the board, but to another ribbon cable. Make sure you disconnect the ribbon cables from each other. |
| + | [* black] Lift all three connectors straight up and away from the boards until the main ribbon cable is free. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0