crwdns2933803:05crwdne2933803:0
crwdns2933797:0Jānis Baumaniscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jānis Baumanis
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Soldering the display module |
|---|---|
| + | [* black] Put a line of flux paste over pads and flat cable end. |
| + | [* black] Take the display module ***with face side down***. Put the flat cable on cleaned pads on circuit board. Arrange the cable over pads to left free pad area a little less than 1mm from the left side (in second photo). |
| + | [* black] Set soldering iron temperature to 270C (520F). Tin the soldering iron and solder the cable to the board. |
| + | [* icon_caution] Be careful. During soldering keep the cable pins directly above related board pads. Try to avoid board overheat though very long heating. |
| + | [* icon_note] Solder the first and last cable pin before soldering the rest, That will keep the cable in place during soldering the remaining pins. |
| + | [* icon_note] Cable soldering is easier with thin oval T12-BC2 tip or other similar tip. Otherwise you will need to use a lot of flux paste to avoid solder clumping in large area with pad shorting in result due to thick tip that help solder spread where it is not desired. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0