crwdns2933803:04crwdne2933803:0
crwdns2933797:0Jānis Baumaniscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jānis Baumanis
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Preparing lifted and torn pads (optional) |
|---|---|
| + | [* black] If during cable removal one or both dead-end pads lifted or got torn off, it is not complete failure yet. You have two options: |
| + | [* black] If pad is lifted, carefully arrange it in old position - different color area (yellowish, not green) under the pad. Put a dab of solder paste over it. Then put solder braid above it and carefully warm the spot for few seconds. let it cool off. Soldering paste will glue the pad black in place. Clean the area afterwards. |
| + | [* black] If pad is completely torn off, inspect the area directly behind it where track from pad went further to small black resistor side. With scalpel carefully scrape off the green lacquer in 1mm length to reveal track copper. Put flux over it and tin the cleared track area. Clean the area afterwards. |