crwdns2933803:011crwdne2933803:0
crwdns2933797:0Tube Timecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tube Time
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] LCD Backlight and LCD Driver Boards |
|---|---|
| + | [* red] Remove the four 6mm self-tapping screws securing both circuit boards. |
| + | [* black] Lift up and remove the LCD driver board (right). |
| + | [* black] Unplug the two small flex cables from the backlight board, being sure to properly unlatch the connectors first. |
| + | [* black] Flip the backlight power board over to the left, exposing the CCFL high voltage wires. |
| + | [* black] Disconnect the two CCFL high voltage wires. |
| + | [* icon_note] The CCFL connectors can be challenging to remove. Try using a spudger to pry the connector+tiny board upwards while using your finger to pull sideways on the connector to disengage the latching tabs. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0