crwdns2933803:09crwdne2933803:0
crwdns2933797:0UnrealKazucrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 UnrealKazu
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Insert the new potentiometer | |
| [* black] Insert the new potentiometer in the same slot as the old one came out of. | |
| - | [* light_blue] Note that the potentiometer has a small clip that neatly falls inside the upper part of the slot. Make sure the potentiometer is oriented so that its clip falls |
| + | [* light_blue] Note that the potentiometer has a small clip that neatly falls inside the upper part of the slot. Make sure the potentiometer is oriented so that its clip falls into this slot as well. |
| [* black] Put both the washer and the nut screw back over the potentiometer, and tighten them with the wrench. | |
| [* black] Grab the knob of the potentiometer with two fingers, and turn it counterclockwise until it stops. | |
| [* black] Place the black cap back on top of the potentiometer, with the white indicator at the start of the green PLA section. | |
| [* black] Once mounted, turn the black knob clockwise all the way, and verify that it is at the end of the dark-red PA section. |