crwdns2933803:07crwdne2933803:0
crwdns2933797:0Richardcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Set your heat gun to the lowest setting(around 150 degrees) | |
| [* black] If you are missing lines on the screen, aim at the top ribbon cables and heat the cable evenly for about 5 seconds. | |
| [* black] Then heat and apply pressure using the plastic opening tool for about 5-10 seconds, applying pressure to different sections of the ribbon cable within that timeframe. | |
| [* black] Continue to apply pressure throughout the ribbons. | |
| - | [* |
| + | [* icon_note] If the screen is Glitchy, do the same for the bottom ribbon cable. |