crwdns2933803:07crwdne2933803:0
crwdns2933797:0Simon Rafaelcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Simon Rafael
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Set your heat gun to the lowest setting(around 150 degrees) |
|---|---|
| + | [* black] If you are missing lines on the screen, aim at the top ribbon cables and heat the cable evenly for about 5 seconds. |
| + | [* black] Then heat and apply pressure using the plastic opening tool for about 5-10 seconds, applying pressure to different sections of the ribbon cable within that timeframe. |
| + | [* black] Continue to apply pressure throughout the ribbons. |
| + | [* black] If the screen is Glitchy, do the same for the bottom ribbon cable. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0