crwdns2933803:01crwdne2933803:0
crwdns2933797:0Stephen Smithcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Stephen Smith
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove screws |
|---|---|
| + | [* black] Start by removing the 2 screws on the bottom of the mouse. |
| + | [* icon_note] You can either remove the rear skate and re-adhere it afterwards or use a 9/64" or 3.5mm drill bit to reveal the holes |
| + | [* icon_note] If you opt to drill a hole through the skate, pressing hard in the area will reveal a indentation where the hole lies |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0