crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Yasminekl1716crwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Yasminekl1716

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_note] In this picture, the device does not have parts like the service armature, and the gearcase attached. These are not required to be taken off for this guide replacement.
-[* red] Unscrew the one screw in the Heat Sync, and take it off of the device.
-[* icon_note] The Heat Sync is attached with an adhesive and may require a little force to take off.
+[* red] Using the Mahi Driver with a T-10 Torx screw bit, unscrew the 22.2mm screw on the heat sink.
+[* icon_note] The heat sink is attached with an adhesive and may require a little force to take off.