crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:08crwdne2933803:0

crwdns2933797:0RodCastlercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 RodCastler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Calibrate the motor speed
-[* black] The speed of the spinning motor may be altered after you just did, mainly because it will experience a lower voltage than before. So we take care of that in this step.
-[* black] Chances are your drive is in working condition by now, ready to take the new 12v power supply. Connect it and give it a go!
-[* black] Time to load your 1050 diagnostic diskette and adjust the trimpot to the desired speed.
+[* black] Chances are your drive is in working condition by now, ready to take the new 12v power supply. So, plug it in and give it a go!
+[* black] At this point, the speed of the spinning motor may be slightly altered. So we take care of that and fix it in this step.
+[* black] Load your 1050 diagnostic diskette and adjust the trimpot to the desired speed.