crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0RodCastlercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 RodCastler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Add the second jumper
-[* black] This jumper is soldered to one of the two pads on the board, right underneath the power jack. The pad you will use is the one closest to the SIO port
-[* black] The other end, goes to the input of the 12v regulator. See the picture for reference, it's the one I'm pointing with the screwdriver. There is a pad right next to it you can use.
+[* black] One end of this jumper wire will be soldered to one of the two pads that are right underneath the power jack. The pad you will use is the one closest to the SIO port and NOT the one below the center of the connector.
+[* black] The other end of the jumper wire, will go to the input of the 12v regulator. See the picture for reference, it's the one below the tip of the screwdriver. There is a pad right next to it you can use.
[* black] ***Alternate reality: ***If you use a good quality, regulated 12v power supply, you can actually solder this end of the wire to the OUTPUT of the 12V regulator for increased efficiency however,
-[* black] by using the input pin instead, the 12v regulator will serve as a protection layer in case anything goes wrong with your power supply or if lightning happens to hit your gaming room!
+[* black] by using the input pin instead, the 12v regulator will serve as protection in case anything goes wrong with your power supply.