crwdns2933803:04crwdne2933803:0
crwdns2933797:0RodCastlercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 RodCastler
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Place the first jumper | |
| + | [* black] With the SIO connectors facing away from you and the front of the unit facing you, locate the four diodes. |
| [* black] Preferably, use 20 AWG wire for the connections. | |
| - | [* black] Solder the first bridge on top of the CR19, which is one of the 4 large diodes (the one at the bottom left with the face of the drive pointing at you and the SIO connectors pointing away from you) |
| - | [* black] You may skip this step if you use a higher voltage (14v or 15v) for your power supply. But if you use a 12v one, adding this jumper is required to minimize the voltage drop. |
| + | [* black] Solder the first bridge on top of the CR19, which is one of the 4 large diodes (the one at the bottom left) |