crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0RodCastlercrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 RodCastler

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[title] Place the first bridge
-[* black] Use preferably 20 AWG wire for these connections.
+[title] Place the first jumper
+[* black] Preferably, use 20 AWG wire for the connections.
[* black] Solder the first bridge on top of the CR19, which is one of the 4 large diodes.
[* black] You may skip this step if you use a higher voltage (14v or 15v) for your power supply. But if you use a 12v one, adding this jumper is required to minimize the voltage drop.