crwdns2933803:03crwdne2933803:0
crwdns2933797:0RodCastlercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 RodCastler
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Prepare the drive | |
| + | [* black] Take a look at the diagram: You are about to add the two jumper wires highlighted in red. |
| [* black] Prepare your Atari 1050 on a clean surface. Put a towel on top of the table to prevent scratches to the unit. | |
| [* black] Remove all 6 philips screws on the underside of the unit | |
| - | [* black] Flip it and remove both the top and front cover as if they were one single piece |
| - | [* black] Take note of the diagram and have it handy for reference while you perform the mod. |
| + | [* black] Flip the unit back on its feet and carefully remove both the top and front cover as if they were one single piece. Be gentle: This plastic is over 40 years old. |