crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:029crwdne2933803:0

crwdns2933797:0Ryan Velascocrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Scott Havard

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* yellow] Extract the speakers connector from the I/O board
+[* yellow] Pull the speakers connector towards you from the I/O board.
[* red] Remove the 3 screws and lift as you see in the picture
-[* icon_note] To replace the speakers you must extract before the motherboard, and after remove 2 visible screws(see the picture in blue circle)
+[* icon_caution] Pull the board a little to the left while lifting to prevent damaging the two attached USB 3.0 ports.