crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Delicately remove the 3 black wires that connect to the display PCB by pulling straight up from the neck of the wire.
- [* icon_note] Try to pull from as close to the connection point as possible to avoid pulling them out at an angle.
+[* red] Use the tip of a spudger to pry up and disconnect the three black antenna cables that connect to the display PCB.
+ [* icon_note] Try to pry as close to the connector point as possible to avoid damaging the cables.