crwdns2933803:03crwdne2933803:0
crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Unplug the battery and remove the rumble motors from their sockets. |
|---|---|
| - | [* black] Peel off the battery from the motherboard. |
| - | [* orange] Remove the two 7 mm Phillips #1 screws holding the board down. |
| + | [* red] Use tweezers to disconnect the battery from the motherboard. |
| + | [* icon_caution] Don't pull on the wires to disconnect the battery. |
| + | [* black] Gently lift the rumble motors out of their housings and set them beside the controller. |
| + | [* icon_caution] Take care not to strain or damage the cables. |
| + | [* black] Gently peel off the battery from the motherboard, with care not to bend or puncture the battery. |
| + | [* orange] Remove the two 7 mm Phillips #1 screws that secure the motherboard. |