crwdns2933803:06crwdne2933803:0
crwdns2933797:0Hannah Vanvlackcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Hannah Vanvlack
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] On the right side of the Cricut, locate the circuit board screwed in to the cover just removed. |
|---|---|
| + | [* black] Locate the four screws securing the circuit board to the shell. |
| + | [* red] Using a J1 screwdriver, unscrew each of the four 10mm screws. |
| + | [* black] Gently unplug the connector from the circuit board, freeing the right side of the plastic shell completely. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0