crwdns2933803:016crwdne2933803:0
crwdns2933797:0BTL Repair AUcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 BTL Repair AU
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Flip the board over. | |
| [* black] Locate the joystick solder nubs on the back of the bottom of the board. | |
| [* black] Using the soldering iron, heat it up to around 350-375 degrees Fahrenheit and lay the tip on the aforementioned nubs. | |
| [* black] Hold it for around 5-7 seconds or until the solder nub liquefies. Repeat this for the rest of the nubs. | |
| [* black] Having done this, the joystick should slide out the board. Install the replacement joystick by sliding in the joystick prongs into the slots that the old joystick sat in. | |
| - | [* icon_note] If the replacement joystick does not slide in properly, check the prongs to make sure they are |
| + | [* icon_note] If the replacement joystick does not slide in properly, check the prongs to make sure they are aligned with the slots. |
| [* black] With the joystick in, solder the prongs until they are secured into place on the boards. |