crwdns2933803:06crwdne2933803:0
crwdns2933797:0Hannah Vanvlackcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Hannah Vanvlack
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Gently unplug the connector located on the roller bar motor. |
|---|---|
| + | [* black] Locate the three screws securing the plate holding the roller bar motor to the Cricut. |
| + | [* black] With the J1 screwdriver bit, unscrew each of the three 5mm screws to remove the motor from the Cricut wall. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0