crwdns2933803:03crwdne2933803:0
crwdns2933797:0Alexander Collinscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alexander Collins
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Orient the printer so that the screen is facing to the right. | |
| - | [* red] Loosen the two 2.5mm socket head screws while holding the extruder head firmly, keeping pressure on the opposite side. |
| + | [* red] Loosen the two 2.5mm X 40mm socket head screws while holding the extruder head firmly, keeping pressure on the opposite side. |
| [* orange] Ensure the screws have cleared the embedded square nuts on the back side. | |
| + | [* icon_note] Be careful not to lose the small springs that are held in place by the screws. |