crwdns2933803:011crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Disconnect the backlight cable |
|---|---|
| + | [* black] Grip the cable close to the head and pull it away from its ZIF connector slowly and steadily to separate the coating. |
| + | [* icon_note] If the coating feels stubborn, reheat the connector and try again. |
| + | [* black] Keep pulling on the cable until it's completely disconnected. |
| + | [* icon_reminder] During reassembly: |
| + | [* black] Inspect the head of the cable and the ZIF connector for any remaining coating that could prevent a good connection. |
| + | [* black] Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle. |
| + | [* icon_note] It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in its connector. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0