crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[* icon_note] The power supply is connected to the bottom of the main board assembly by [link|https://guide-images.cdn.ifixit.com/igi/SgmeJAe6rOoYkdfd.full|metal prongs|new_window=true] that plug into the bottom left corner.
[* black] Insert the flat end of a spudger between the board and the lower shield plate, by the [link|https://guide-images.cdn.ifixit.com/igi/J3xv3ABvVlsjnP2b.full|two parallel solder joints|new_window=true] near the corner with the power button.
-[* black] Twist the spudger to lift the two prongs that are under the board out of their socket.
+[* black] Twist the spudger to lift the two prongs under the board out of their socket.
[* icon_note] You should feel the prongs slide out.
-[* icon_reminder] ***Is this necessary during reassembly? Could it put uneven pressure on the board?*** During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place.
+[* icon_reminder] During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place.