crwdns2933803:04crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Insert the flat end of a spudger between the board and the lower shield plate, by the [link|https://guide-images.cdn.ifixit.com/igi/CX6JwXnsDrovR1SJ.full|two parallel solder joints|new_window=true] near the corner with the power button. |
|---|---|
| + | [* black] Twist the spudger to lift the two prongs that are under the board out of their socket. |
| + | [* icon_note] You should feel the prongs slide out. |
| + | [* icon_reminder] ***Is this necessary during reassembly? Could it put uneven pressure on the board?*** During reassembly, press down on the corner of the board to fully seat the prongs in the power supply—you should feel them slide into place. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0