crwdns2933803:013crwdne2933803:0
crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Repeat the previous step for the other corner until the entire cable is disconnected. | |
| [* black] Lift up the cable and peel off any remaining coating holding it to the motherboard. | |
| - | [* icon_reminder] During reassembly, follow [guide|170440|this guide|new_window=true] to clean off any remaining coating on the display cable and its ZIF connector. |
| + | [* icon_reminder] During reassembly: |
| + | [* black] Inspect the ends of the cable and the ZIF connectors for any remaining coating that could prevent a good connection. |
| + | [* black] Peel off the coating, heating the cable and the ZIF connector when the coating becomes too brittle. |
| + | [* icon_note] It doesn't have to look pretty! You just need to remove enough coating to have the cable sit properly in the connector. |