crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Use pointed tweezers to peel off the coating around the locking tab and its hinge on the ZIF connector.
- [* icon_note] If the coating becomes too brittle and hard to peel off, reheat the daughterboard and try again.
+ [* icon_note] If the coating becomes too brittle and hard to peel off, reheat the power button board and try again.
[* icon_caution] This is a meticulous process! Failure to remove enough of the coating could damage the locking tab during disconnection, so take your time!