crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Shahram Mokhtaricrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Shahram Mokhtari

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Remove the black wires
[* black] Pry away the glue at the base of the connector.
[* icon_note] It is possible to remove the glue without applying heat but the risk of damage to the cables increases.
[* black] Use a spudger to lift the plastic tabs on the connector and remove the black wires.
[* black] Tape the three black wires together.
-[* icon_caution] ***Make sure the ends of the black and red wires don't touch. ***This could create a short and may send the battery into thermal runaway. While the battery management system has protections in place to prevent this, it's best not to take any chances.
+[* icon_caution] ***Make sure the ends of the red wires don't touch any of the other wires. *** This could damage the battery circuitry.