crwdns2933803:04crwdne2933803:0
crwdns2933797:0Shahram Mokhtaricrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Shahram Mokhtari
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the black wires |
|---|---|
| + | [* black] Pry away the glue at the base of the connector. |
| + | [* icon_note] It is possible to remove the glue without applying heat but the risk of damage to the cables increases. |
| + | [* black] Use a spudger to lift the plastic tabs on the connector and remove the black wires. |
| + | [* black] Tape the three black wires together. |
| + | [* icon_caution] Make sure the ends of the black and red wires do not touch. This could create a short and may send the battery into thermal runaway. While the battery management system has protections in place to prevent this, it's best not to take any chances. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0