crwdns2933803:02crwdne2933803:0
crwdns2933797:0OpenDesigncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 OpenDesign
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Open the casing |
|---|---|
| + | [* black] The casing consists of two injection molded plastic parts which have been sealed. To open the device, a Dremel was used with a rotary blade to cut at the parting line between the two parts. Cutting was initiated at the micro-USB port and then progressed all around the seam. |
| + | [* icon_note] In this case, the cutting was very shabbily done. However, it would be possible to carefully cut along the seam to obtain the two individual casing parts. |
| + | [* icon_caution] Use appropriate protective gear to prevent cuts on the skin and prevent small particles from entering your eyes and mouth while using the Dremel. |
| + | [* black] Inside the casing was a PCB and a battery soldered and glued to the PCB. |
| + | [* black] The device communicates through a micro-USB port. It is not a water-resistance device as the USB port is exposed. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0