crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Alex Diaz-Kokaislcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Diaz-Kokaisl

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Unfasten the triggers
[* red] Use a Phillips screwdriver to remove the two 3.4 mm‑long screws securing each trigger (four screws total).
[* icon_reminder] To install a trigger:
- [* black] Pull the trigger in and firmly push it into place so the cutouts on the hinge [link|https://guide-images.cdn.ifixit.com/igi/4QHjDBVZGZMUoqBG.full|go over their alignment posts|new_window=true]. The trigger should stay in place.
- [* red] Keep the trigger slightly pulled in and install the screws.
- [* black] Test the triggers before continuing reassembly. If they aren't working properly, remove them and go back two steps to make sure the trigger is properly aligned on the hinge.
+ [* black] Compress the trigger and firmly push it into place on the chassis so the cutouts on the hinge [link|https://guide-images.cdn.ifixit.com/igi/4QHjDBVZGZMUoqBG.full|go over their alignment posts|new_window=true]. The trigger should stay in place.
+ [* black] Keep the trigger compressed and install the screws.
+ [* black] Test the triggers before continuing reassembly. If they aren't working properly, remove them and make sure the trigger is properly aligned on the hinge.