crwdns2933803:01crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the triggers |
|---|---|
| + | [* red] Use a Phillips screwdriver to remove the two 3.4 mm‑long screws securing each trigger (four screws total). |
| + | [* icon_reminder] To install a trigger: |
| + | [* black] Pull the trigger in and firmly push it into place so the cutouts on the hinge [link|https://guide-images.cdn.ifixit.com/igi/4QHjDBVZGZMUoqBG.full|go over their alignment posts|new_window=true]. The trigger should stay in place. |
| + | [* red] Keep the trigger slightly pulled in and install the screws. |
| + | [* black] Test the triggers before continuing reassembly. If they aren't working properly, remove them and go back two steps to make sure everything is properly aligned and installed. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0