crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:012crwdne2933803:0

crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Remove the two gold screws (7mm) from the silver cable bracket of motor mount on the bottom of the device using a Torx T6H screwdriver.
-[* black] Remove the bracket and pull away the ribbon cable and disconnected motor component.
-[* icon_note] The ribbon cable is held in place by a small spot of adhesive above the bracket. Gently pull away the ribbon cable to break the seal, or use a softer tool such as a plastic pry tool or spudger to wear it away.
+[* red] Use a T6 Torx screwdriver to remove the two 7 mm screws from the silver cable bracket on the motor mount.
+[* black] Remove the bracket, pull away the ribbon cable, and remove the motor.
+ [* icon_note] The ribbon cable is held in place by a small spot of adhesive above the bracket. Gently pull away the ribbon cable to break the seal, or a nylon spudger to work through it.