crwdns2933803:010crwdne2933803:0
crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Pry the connected side of the ribbon cable up and off the board using an opening tool to disconnect that side. |
|---|---|
| + | [* red] Place the tip of your opening tool under the edge of the press connector, and pry the connector straight up from its socket. |
| + | [* icon_caution] Be very careful to pry only under the edge of the connector, and not under the socket itself. If you pry under the socket, you will separate it from the circuit board, which requires specialized microsoldering skills and equipment to repair. |
| + | [* icon_reminder] To reconnect, align the connector carefully over its socket and press down with your fingertip—first at one side, then the other—until it clicks into place. |