crwdns2933803:05crwdne2933803:0
crwdns2933797:0Albert Wucrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Albert Wu
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the broken locking solenoid |
|---|---|
| + | [* black] Disconnect the 2-pin connector (in red box) connecting the locking solenoid to the main PCB. |
| + | [* black] Remove the 4 M2 screws (red arrows) that fasten the locking solenoid. |
| + | [* black] The locations of the screws may be obstructed by the robot fairing, PCB, and the black cap. |
| + | [* black] Rotate the robot (see step 3) and shift the black cap around (see step 4) to gain access to the screws. |
| + | [* black] Be careful not to damage any cables or protruding electronics. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0