crwdns2933803:01crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unfasten the MagSafe port | |
| [* red] Use a T2 Torx driver to ***loosen*** the two set screws in the frame that align the MagSafe port. | |
| [* icon_note] Don't remove these screws. Just loosen them a few turns above the frame. | |
| - | [* orange] Use your Torx |
| - | [* icon_note] These screws are non-magnetic |
| + | [* orange] Use your T5 Torx driver to remove the two 2.7 mm-long 5IP Torx Plus screws securing the MagSafe port. |
| + | [* icon_note] These screws are non-magnetic—be careful not to lose them. |