crwdns2933803:01crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the MagSafe port |
|---|---|
| + | [* red] Use a T2 Torx driver to ***loosen*** the two set screws in the frame that align the MagSafe port. |
| + | [* icon_note] Don't remove these screws. Just loosen them a few turns above the frame. |
| + | [* orange] Use your Torx Plus 5IP driver to remove the two 2.7 mm-long screws securing the MagSafe port. |
| + | [* icon_note] These screws are non-magnetic, so be careful not to lose them. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0