crwdns2933803:03crwdne2933803:0
crwdns2933797:0Clay Eickemeyercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Clay Eickemeyer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the antenna bar |
|---|---|
| + | [* red] Use a P2 pentalobe driver to remove the nine 1.6 mm-long screws securing the antenna bar. |
| + | [* icon_reminder] During reassembly, don't overtighten these screws—ensure that they're threading in properly, then tighten only until they're snug. |
| + | [* black] Use your Torx Plus 5IP driver to remove the six remaining screws securing the antenna bar: |
| + | [* orange] Four 3.2 mm-long screws |
| + | [* green] Two 7.5 mm-long screws |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0