crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Edwin C.crwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Edwin C.

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Screw the 8 hex screws (#2.5) back onto the frame of the controller.
-[* icon_note] Tighten by hand to hold the gimbal into place, then finish with your choice of hex tool (#2.5).
+[* icon_note] Tighten by hand to hold the gimbal into place, and finish with your choice of hex tool (#2.5).