crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Marcos Shipleycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Marcos Shipley

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* icon_reminder] When removing the tail light there are little hooks with holes that are used to hold them in place as shown in the first photo.
[* icon_note] The tail should already be lose from the previous step so you can pull it out slowly by turning it on its side then pulling forward.
-[* red] Now you'll need to unscrew the screws that hold the brake light bulbs in the tail light.
+[* red] Use the 7 mm socket to unscrew the two bolts securing the brake light housing to the tail light assembly.
[* icon_note] The screws in this step are "Rexka 30pcs M4.2-1.41 x 20mm" and I used a 7mm socket drive on the Philips screwdriver to get the screws loose.