crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Richardcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Take off the 7 4.32mm diameter 8mm long silver screws holding the PCB to the black housing on the wheel using bit J0.
-[* red] Move the PCB to the side to expose the back side of the red dial. Keep the remaining white cable connected to the secondary PCB.
-[* red] Be careful not to lose the buttons and D-pad because once the PCB was removed they can easily be lost.
+[* black] Move the PCB to the side to expose the back side of the red dial. Keep the remaining white cable connected to the secondary PCB.
+[* icon_note] Be careful not to lose the buttons and D-pad because once the PCB was removed they can easily be lost.