crwdns2933803:05crwdne2933803:0
crwdns2933797:0Nicholas Clausercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nicholas Clauser
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Remove the screw located in the M.2 slot. This screw is a 2mm Philips. Placeholder image shown. | |
| [* icon_caution] Do not lose this screw! It must be reused later. | |
| - | [* green] Gently grasp the SSD from |
| + | [* green] Gently grasp the SSD from where the screw was located. |
| [* yellow] Pull the SSD to remove it from the M.2 slot. If the SSD does not immediately release, ***gently ***wiggle it while pulling. | |
| - | [* black] Pull the SSD out of the heatshield. The heatshield will be reused with the new hard drive. |
| - | [* icon_note] Pay attention to the positioning of the hard drive as it were installed in the socket. You will install the new SSD using the same orientation in the next step. |
| + | [* black] Once you have removed the old hard drive, pull it out of the plastic heatshield. This heatshield will be reused with your new hard drive. |