crwdns2933803:02crwdne2933803:0
crwdns2933797:0KenFcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 KenF
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Mount New Switch |
|---|---|
| + | [* black] I mounted the new switch in the location of the old switch button. There is a hole mostly there already if you just cut the remaining plastic to leave about a 3/8" hole. |
| + | [* black] You'll need to trim down the small plastic posts that held the switch circuit board in place. |
| + | [* black] The switch doesn't have a lot of threads, so you can't use thick washers. I used a 5/16" speed nut on the inside, which also helps keep the switch centered since hole is a little bit bigger than needed. |
| + | [* black] On the outside I used a thin plastic washer, then the nut for the switch. |
| + | [* black] Bend the tabs down as pictured so wiring will fit when reassembled. Tighten nut. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0