crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Bencrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Remove the six 6.2 mm screws using a Phillips #00 screwdriver
[* black] Remove the 2.3 mm screw located above the game cartridge slot with a Phillips #00 screwdriver.
-[* black] Make sure the SD card has been removed. With a plastic opening tool pry off the lower case starting at the bottom edge and working around the perimeter.
+[* black] With a plastic opening tool pry off the lower case starting at the bottom edge and working around the perimeter.
[* black] Two ribbon cables connect the case to the circuit board. Be careful to not pull the case too hard and rip the ribbon cables.