crwdns2933803:022crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Reassembly information | |
| [* icon_note] If you're installing a new screen with pre-installed adhesive, follow this step ''during reassembly''. Otherwise, follow [guide|165811|this guide|new_window=true] to apply adhesive to your old screen. | |
| - | [* red] Thoroughly check the ''entire'' screen for any plastic liners or tape and use the pull tabs to remove them. Look carefully near the front camera cutout, |
| + | [* red] Thoroughly check the ''entire'' screen for any plastic liners or tape and use the pull tabs to remove all of them. Look carefully for a large piece of plastic covering the back of the screen, a small one near the front camera cutout, and adhesive liners around the perimeter. |
| [* black] Reconnect the screen cable and reinstall its cover. | |
| [* black] This is a good point to test your phone before sealing it up. Temporarily power on your phone and make sure it works as expected. Power it down before continuing. | |
| [* black] Firmly press the screen into place on the frame—you should feel the clips "pop" into place. | |
| [* black] Press firmly around the perimeter of the screen to secure it with the new adhesive. | |
| [* icon_note] Optionally, you can strengthen the adhesive bond by [guide|165811|applying pressure evenly to the phone|stepid=349253|new_window=true]. | |
| [* black] Follow [guide|166753|this guide|new_window=true] to calibrate the fingerprint sensor. |