crwdns2933803:06crwdne2933803:0
crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unfasten the I/O board |
|---|---|
| + | [* red] Use a T4 Torx screwdriver to remove the two 15.5 mm‑long screws securing the outer edge of the I/O board. |
| + | [* orange] Use a T6 Torx screwdriver to remove the two 20 mm‑long screws securing the inner edge of the I/O board. |
| + | [* icon_reminder] During reassembly: |
| + | [* black] Partially tighten the four screws securing the board. |
| + | [* black] Plug a cable into one of the ports and ensure proper fit and alignment—the cable should be easy to insert and remove. |
| + | [* black] With the cable plugged in and the board in position, fully tighten all four screws. |
| + | [* black] Test the fit of each port. If any of them don't fit, loosen the screws and try again. |
| + | [* black] ***Unplug all cables before continuing.*** |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0