crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0Caius Nocturnecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Caius Nocturne

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] (Re-assembly) Re-attach side panel to bottom (Part 2)
[* icon_note] ***This step is for reassembly only.***
-[* red] While holding the back divot/hole in place, lay the front of the numpad assembly relatively straight over the bottom case.
- [* icon_caution] Holding the rear sections of the two parts together are important as the plastic is thin on the bottom assembly here and it can easily bend if you try to apply downward force here.
-[* orange] Firmly press the numpad case into the bottom case at the front. The two should snap together.
+[* red] While holding the back divot/hole in place, lay the front of the numpad panel relatively straight over the bottom panel.
+ [* icon_caution] Holding the rear sections of the two panels together are important as the plastic is thin on the bottom assembly here and it can easily bend if you try to apply downward force here.
+[* orange] Firmly press the numpad panel into the bottom panel at the front. The two should snap together.