crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Spencer Daycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Day

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Remove the midframe.
+[* black] Remove the rear shell.
[* icon_reminder] During reassembly:
- [* red] Thread the bumpers button board cable through its slot in the midframe.
- [* black] Lay the midframe on the frame, so its bottom edge is slightly lower than the frame.
- [* icon_note] This allows the tabs to slide into place. If the midframe is perfectly flush with the frame, the tabs won't slide.
- [* orange] Press down and slide the midframe up to engage the sliding tabs.
+ [* red] Thread the bumpers button board cable through its slot in the rear shell.
+ [* black] Lay the rear shell on the front shell, so its bottom edge overhangs slightly.
+ [* icon_note] This allows the tabs to slide into place. If the rear shell is perfectly flush with the front shell, the tabs won't slide.
+ [* orange] Press down and slide the rear shell up to engage the sliding tabs.