crwdns2933803:02crwdne2933803:0
crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Carefully lay the iMac stand-side down on a flat surface. |
|---|---|
| + | [* icon_note] Due to tight tolerances, you will have to use a thin hooked tool to lift the display out of the outer case. As seen in the third picture, we made one out of a bent paperclip. |
| + | [* black] Use a thin hooked tool to lift one side of the top edge of the display by its steel outer frame. |
| + | [* icon_note] After lifting the top edge of the display on one side, hold it out of the outer case while you use a hooked tool to lift the other side. |
| + | [* icon_caution] Do not lift the top edge of the display out of the outer case too far, as several short ribbon cables still connect the two components. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0